Low Humidity Steady State Test Chamber

Home > Low Humidity Steady State Test Chamber

LOW HUMIDITY(Steady State) TEST CHAMBER MODEL: ENV-033

Purpose

The Chamber is used to carry out Low Humidity Steady State Tests at any temperature within specified limit. Though it is not suggested by any standard, some laboratory wants to simulate too dry condition

Test Conditions :

  • Temperature: 50 C to 500 C
  • Relative Humidity: 5% to 30% Rh
  • Lower Dew Point Temperature: -250 C

STANDARD SIZE OF CHAMBERS

Final Model

Work Space

(H x W x D)

Static Load

of Steel

Thermal loadNo. of Selves
ENV-033-125 Liter – A OR B50 x 50 x 50 cm10 Kg20 watts1
ENV-033-450 Liter – A OR B75 x 75 x 80 cm25 Kg50 watts2
ENV-033-1000 Liter – A OR B100 x 100 x 100 cm50 Kg100 watts2
*ENV-033-CB – A OR BCustom Built (Specify H x W x D)SpecifySpecifyNot required

* We have delivered Hot, Cold & Humidity Chamber up to 10 x 4.5 x 3.5 meter size.

Standard Features :

  • Sealed compressor is used for cooling purpose.
  • Humidity Generation: Controlled water evaporation
  • Dehumidification System: Using desiccant technology
  • Temperature sensing by Pt-100 sensor
  • % Rh sensing by capacitive RH sensor
  • Control accuracy: Better than +/- 0.5° C and +/-2% Rh (+/-10 C and +/-3% RH for Walk In Chambers)
  • Selves are provided which can be adjustable throughout height
  • Standard Port Holes: 50 mm / 100 mm / 150 mm diameter (Specify)
  • Multilayer observation window with illumination
  • Caster wheel up to 1000 Liter models
  • Ambient condition: 10° to 45° C

Control Instrumentation: Multispan or equivalent controller

Optional Accessories:

  • Two channel Paperless chart recorder
  • Two channel data logger

Major Safety Protection:

  • Independent workspace over & under temperature protection
  • High discharge and low suction pressure correction before tripping
  • Refrigeration compressor tripping abnormal high discharge and low suction pressure
  • Over current Relay (OLR) and MCBs are provided as required

Power Supply:

  • 415 Volt – 50 Hz – 3Φ – N – E
  • 230 Volt – 50 Hz -1Φ – E

Provide Minimum Information While Rising Inquiry to Get Precise Quotation:

  • Select final model number from Table 1.
  • Please give Chamber size (Width x Depth x Height) and Thermal load in case of Model: ENV-021-CB
  • Numbers of port holes and size (Size is mentioned above)
  • Air cooled or water cooled condenser. (We will decide for water cooled condenser for large size chambers)
  • Optional accessories (Select from above)
  • Specify any additional facility if needed

Electric Supply Option:

  • 415 Volt – 50 Hz – 3Φ – N – E
  • 230 Volt – 50 Hz -1Φ- E

Cost Controlling Factors:
Many parameters like temperature range, workspace size, controllers, cooling rate etc. are affecting the cost. Therefore, be careful while providing such details to control cost of the chamber.

Print Friendly, PDF & Email